Show: Delphi C++
Display Preferences

Enabling USB Debugging on an Android Device

From RAD Studio
Jump to: navigation, search

Go Up to Android Mobile Application Development


The steps to enable USB debugging depend on the version of Android running on the target device, as indicated in the following table:

Android Device Instructions

Android 4.0 and newer (Jelly Bean)

Enable the USB Debugging option under Settings > Developer options.

For Android 4.2 and newer, Developer options is hidden by default; use the following steps:

  1. On the device, go to Settings > About <device>.
  2. Tap the Build number seven times to make Settings > Developer options available.
  3. Then enable the USB Debugging option.
    Tip: You might also want to enable the Stay awake option, to prevent your Android device from sleeping while plugged into the USB port.

For more information, see Unlocking Jelly Bean and Higher Devices

Kindle Fire devices

Select Settings > Security and set Enable ADB to On.
For more information, see the Amazon documentation.


If you are running Android 4.2.2 or later, you may see the following dialog when you connect your device to your PC running RAD Studio:

AndroidEnableUSBDebuggingDialog.png

Click OK to allow USB debugging on your PC. If you accidentally click Cancel, disconnect your device from your PC and connect it back to make the dialog show up again on your device.

Troubleshooting

If your Android device is not correctly detected by RAD Studio or the system Device Manager, follow the steps above to verify that USB debugging is enabled.

For general information about development setup for Android devices, see the Android documentation.

See Also

Personal tools
In other languages